Audi Q7 Headlight Bulb Replacement

Estimated time:

0.25h

Estimated cost:

Applicable models:

Audi Q7 2007-2015

Tools used:

Flat Blade Screwdriver

Parts used:

Philips D1S HID Bulb

Other Related Parts:

Ballast

Left Headlight

Right Headlight

Headlight Mount Bracket

Headlight Bulb Cover

Headlight Retaining Clip

In this article we will show you how to change your Audi Q7 headlight bulb. If you have any questions or concerns please add them to the comments below.

Procedure

Step 1: Start by popping the hood of your Q7. This hood release lever is located on the lower portion of the driver side kick panel.
Step 2: Once the hood is popped the next step is to pop the side retaining clip to its upper position. Use a flat blade screwdriver to get some leverage on the clip. Lift up until it seats in the upper position. It is possible to completely remove the clip so be careful not to lose it if it comes all the way out.
Step 3: Use a flat blade screwdriver to press the exterior retaining tab while pushing on the rear of the headlight. If done correctly the headlight should move forward a couple of inches. This will give you enough room to remove the bulb cover in the next step.
Step 4: Grip the tab on the bulb cover located on the rear of the headlight. Slide the cover towards the center of the car. Remove the cover from the headlight assembly.
Step 5: There is a black plastic ring that holds the bulb inside the headlight. You will need to spin the ring counter clockwise about 1/4 of a turn.
Step 6: Once the retaining ring is loosened you can then pull the bulb our of the socket and disconnect the plug.
Step 7: Please just follow this article in reverse to install the bulb. IMPORTANT! Do Not Touch the glass of the new bulb.

Troubleshooting

My bulb burnt out shortly after I installed it

There was oil or some other contaminate on the bulb causing a hot spot. This will shorten the bulb life significantly. Please be sure to not touch the glass portion of the bulb.

None of my bulbs work

Check the headlight connector to make sure it is not damaged and is seated correctly.

My new bulb does not work (low beam)

Please check to make sure the headlight connector is seated all the way
If the connector is seated correctly and the bulb is new changes are you have a bad HID ballast.

I touched the glass of the bulb what can I do?

Make sure the bulb is free from any oil from your finger or other contaminants. Use isopropyl alcohol and a lint free cloth to clean the bulb before installing.

How much is a used Audi Q7 (’07-15) headlight?